New construction ductwork
We size and lay out ducts for the house and the equipment together, so every room gets the air it needs. We work with builders and owners from framing through final.
PNW
Spokane Heating & Air
Your furnace or heat pump can only deliver what the ducts carry. We design and install duct systems for new homes and remodels, seal leaky runs in attics and crawlspaces, and fix the rooms that never feel right, across Spokane, Spokane Valley and Mead.
Ductwork near you
Most people judge their heating by the furnace. But the furnace only makes the heat. The ducts decide where it goes, and how much of it makes it there. A brand new, high-efficiency furnace hooked to leaky, undersized or crushed ducts will still leave you with cold bedrooms and high bills.
Around Spokane, a lot of ductwork runs through attics, crawlspaces and garages, the parts of the house that sit close to outdoor temperature. In a January cold snap, with lows averaging around 24°F, every loose joint in those spaces is pushing warm air you paid for into a place nobody lives.
Duct leaks are rarely one big hole. They're dozens of small gaps: seams that were never sealed, flex duct that slipped off a collar, old cloth tape that dried out and let go years ago. We track them down by inspecting every run we can reach and checking the airflow at your registers. Then we reconnect what's loose and seal joints with duct mastic or foil tape made for the job. Cloth duct tape, despite the name, doesn't hold up on ducts.
The bonus room over the garage. The basement bedroom. The far end of a long ranch house. Hot and cold rooms usually come down to airflow: a supply run that's too small or too long, dampers set wrong, or no clear path for air to get back to the furnace. That last one, return air, gets missed a lot. When a bedroom door is closed and there's no return in the room, air can't circulate, and the room never catches up. We fix it with balancing dampers, added returns, transfer grilles or resized runs.
Warning signs
Duct trouble hides behind walls and under insulation, so it usually shows up as comfort or cost problems first.
What we do
From a single disconnected run to a full duct system for a new house, done by the same local crew.
We size and lay out ducts for the house and the equipment together, so every room gets the air it needs. We work with builders and owners from framing through final.
Finishing a basement or adding a room? We extend or rework the ductwork so the new space heats and cools like the rest of the house, without starving the old rooms.
We reconnect loose runs, replace crushed or torn sections and seal leaky joints with mastic or foil tape, so heated air ends up in your rooms instead of the attic.
We adjust dampers, add returns and resize problem runs to even out hot and cold rooms. Then we check the airflow again to confirm it worked.
After a remodel, a pest problem or moisture that caused visible mold, a proper cleaning is worth it. We'll tell you straight if your ducts don't need it.
Ducts in attics and crawlspaces lose heat along the way. Sealing first, then insulating, keeps more of that warm air warm until it reaches the room.
How it works
We don't guess at ductwork. We look, measure and show you what we found before anything gets cut or sealed.
Which rooms, what time of year and what you've already tried. For new builds, send plans if you have them.
We go into the attic, crawlspace and basement, check every run we can reach and measure airflow at the registers.
You see what we found, what we recommend and what it costs. You approve the price before work starts.
We make the repairs, rebalance the system and check the airflow again so you know the fix actually worked.
Honest duct cleaning
If you've just finished a remodel with drywall dust everywhere, found signs of mice, or had moisture problems that left visible mold (after the moisture itself is fixed), cleaning is worth doing. If you just want less dust in the house, a better filter and sealed return ducts usually do more for less money. We'll look inside and tell you which one you actually need.
Attics and crawlspaces
An air handler in the attic or a trunk line running through a crawlspace works, but it's working in a space that can be close to freezing in winter and well over 100°F in a July attic. Bare or poorly insulated ducts in those spaces give up heat in winter and soak it up in summer, so the air coming out of your vents is weaker than what the equipment made.
The right order matters. We seal the joints first, because insulation wrapped over a leak just hides it. Then we insulate the runs and fittings so the air arrives close to the temperature it left the furnace or heat pump. In crawlspaces, we also look for moisture and pests, since damp or damaged duct wrap needs to be replaced, not patched.
Building new or replacing your equipment? The best time to get ducts right is before the drywall goes up. We can quote the ductwork and the system together.

Our work
Our own jobs, photographed on site. No stock photos.






Ductwork FAQ
Have a question that isn't here? Call (509) 410-0769 and ask a real person.
Common clues are rooms that never get warm, weak airflow at some vents, extra dust and heating bills that creep up. If you can safely look in your attic or crawlspace, disconnected or crushed runs are easy to spot. Most leaks are small and hidden, though, so an inspection is the reliable way to find them.
No. Most homes don't need routine yearly duct cleaning. It's worth it after a remodel, a pest problem, visible mold or when there's heavy debris inside the ducts. For everyday dust, a good filter changed on time does more. We'll look inside and give you an honest answer.
Usually it's airflow. The run to that room may be too long or too small, leaking in the attic, or there may be no return path when the door is closed. Rooms over garages and in basements are the usual suspects. Balancing, sealing or adding a return typically fixes it. For a room that's far from the ducts, a ductless mini split can be a better answer.
Yes. We'll check whether your current furnace or heat pump has enough capacity for the added space and extend the ducts to match. If it doesn't, we'll give you options, from resizing to a separate system for the new area.
Yes. Those spaces get close to outdoor temperatures, so bare ducts lose a lot of heat in a Spokane winter and gain heat in summer. Seal the joints first, then insulate. Damaged or wet duct wrap should be replaced.
Not when it's installed right. Flex duct works well in short runs that are pulled snug, supported properly and free of kinks. The trouble comes from long, sagging or crushed runs, which choke airflow. We fix or replace those sections when we find them.
Yes. We design and install duct systems for new homes and larger remodels around Spokane, Spokane Valley and Mead, and we can supply the furnace or heat pump too. Qualifying new system installs include our 10-year parts and labor warranty. Request a free estimate.
Related services
Ductwork across Spokane County, from our shop in Mead.

Book service
Tell us which rooms are too hot, too cold or too dusty, or what you're building. We'll set up a duct inspection or a quote for new ductwork.