Thermostat repair
Loose or corroded wiring, bad sensors and calibration errors. Old wire in old walls gets brittle, so we check both ends of the run.
PNW
Spokane Heating & Air
A round dial on a plaster wall in Browne's Addition. A touchscreen in a new two-story off Five Mile Road. Both decide how warm your family stays all winter. We repair, replace and set up thermostats all over the city, with the price approved before we start.
Spokane thermostats
When a home won't stay comfortable, the thermostat is the first thing we check, and good thermostat service in Spokane, WA starts with knowing what's on the other end of the wire. This city has nearly every kind of heating system there is, and a thermostat that works great on one can misbehave badly on another.
On the South Hill, in Manito, Cliff/Cannon, Logan and Hillyard, we still find mercury dial thermostats running furnaces installed long after the dial. Many of these houses have only two thin wires behind the plaster, which is enough for a basic thermostat but not for most smart ones. Fishing a new wire through lath and plaster walls isn't always practical, so we often add power at the furnace end instead. Homes that still heat with a boiler and radiators need a thermostat built for boiler controls, and we make sure you get one.
In North Spokane, Nevada-Lidgerwood and on Five Mile Prairie, the issues are different: two-stage furnaces run by single-stage thermostats, heat pumps leaning on backup heat, and bonus rooms over the garage that never match the main floor. These are setup problems, and they're very fixable.
For the basics on thermostat types, C-wires and placement, see our full thermostat guide.
What we do
Five services, one goal: a house that holds the temperature you set.
Loose or corroded wiring, bad sensors and calibration errors. Old wire in old walls gets brittle, so we check both ends of the run.
Out with the worn or confusing unit, in with one that fits your system. Old mercury thermostats get recycled, never tossed.
Powered properly, connected to Wi-Fi and set up on your phone before we leave, even in houses with only two wires.
We build a schedule around your real week, with sensible winter setbacks, and show you how to change it.
Furnace stages, heat pump backup heat, boiler controls. We confirm the match before anything goes on your wall.
If the thermostat is fine and the furnace isn't, we'll tell you. See furnace service in Spokane.
Spokane weather, both ends
Winter nights here average about 24°F, so a sensible overnight setback can trim gas use. Summers bring heat, like the 109°F of the 2021 heat dome, and wildfire smoke most Augusts and Septembers. On smoky days we often set the fan to circulate through a good filter, so the air keeps moving through it even when the AC isn't calling. A thermostat set up for only one season leaves comfort and money on the table.
Drafty houses, honest readings
Early 1900s houses were built with tall ceilings, big single-pane windows and little insulation. The thermostat was often hung wherever the old wire came up, sometimes on an outside wall or in a hallway by the front door. In January it reads the draft, not the living room, and the furnace runs far longer than the rest of the house needs.
Sometimes the fix is moving the thermostat a few feet. Sometimes it's a model with a remote sensor you set in the room you actually use. And when one floor is always behind, the cause is often ducts, not the thermostat at all. We'll check your ducts and tell you which it is.
From our recent jobs



Thermostat FAQ
Not sure what you have? Text a photo of your thermostat to (509) 410-0769.
Watch for a blank screen with fresh batteries, readings that don't match the room, or a furnace that ignores changes. In older homes, also look for a dial that sticks or a unit that's no longer level, since many old thermostats read wrong when tilted.
They can, when they're set up well. Savings come from setbacks while you sleep or are away. Spokane's long heating season gives a schedule more chances to pay off, but in a drafty older home, the bigger win may be fixing where the thermostat sits.
We install and service most major brands, including Bosch. What matters more than the brand is that it matches your furnace, heat pump or boiler, and we confirm that first.
A straight swap or repair is usually a short visit. Adding power for a smart thermostat in a house with old wiring, or setting up a heat pump, takes a bit longer. We'll tell you what to expect when you book.
We check and calibrate the thermostat as part of a furnace tune-up. If it needs repair or replacement, we'll give you the price before doing the work. See our maintenance plans.
Usually, yes. We can add a power adapter at the furnace or pick a model designed for low wire counts. It's one of the most common jobs we do in older Spokane neighborhoods.
Many boilers work with smart thermostats, but not every model supports every boiler control. We check the wiring and the boiler before recommending one. More on boilers at boilers and radiant heat.
Thermostat service near you
From our Mead shop to every corner of the city. On the east side of the line? See thermostat service in Spokane Valley.

Book service
Tell us what heats your home, roughly how old the house is and what the thermostat is doing. We'll check compatibility before we show up so the visit is quick.